LSU 4.9 Lambda WideBand O2 Oxygen Sensor for PLX UEGO AEM 30-4110 30-0300 30-2004 X-Series AFR Inline Replace Bosch 0258017025
You will be redirected to AliExpress to complete your purchase
Specifications
- Brand Name
- NONE
- Sensor Type
- Differential Holzer
- High-concerned chemical
- None
- Electronic
- No
- Origin
- Mainland China
- OEM NO.
- 17025 0258017025
- Feature 1
- Most 4.9 LSU Wideband Controller Gauge
- Feature 2
- AEM 30-4110 Digital Wideband UEGO Gauge
- Feature 3
- AEM 30-0310 X-Series Inline Wideband UEGO AFR Controller
- Feature 4
- 5-Wire UEGO Air Fuel Ratio Sensor
- Choice
- yes
Product Description
Reduce Car Fuel Consumption! Replace the Oxygen Sensor Yourself
LSU 4.9 Lambda WideBand O2 Oxygen Sensor for AEM 30-4110 30-0300 30-0310 - X Series AFR Inline Controller - UEGO A/F Ratio Wideband 02 Gauge | Replace 17025, 0258017025
Package Include:
1pcs x, 0258017025 Oxygen Sensor
OEM Part Number ：
17025, 0258017025, 304110, 300300, 300310 30-4110, 30-0300, 30-0310
Fitments:
Most 4.9 LSU Wideband Controller Gauge
AEM 30-4110 Digital Wideband UEGO Gauge
AEM 30-0300 X-Series Digital Wideband UEGO AFR Gauge
AEM 30-0310 X-Series Inline Wideband UEGO AFR Controller
Product Details
Description:
Condition: 100% Brand New & High Quality
Color: As picture show
Material: ABS + Metal
Connector: 4 6ins
Wires：5Wires
UpstreamFitment Type: Direct ReplacementFeatures: Durable and long service lifeService life100000 to 200000 kilometers
Replace the oxygen sensor in the following situations
After replacing the oxygen sensor
O2 Sensor Installation Steps
①Disconnect the battery
Prevent accidental short circuits.
②Locate the old sensor
Usually found on the exhaust manifold or pipe.
③Unplug the sensor connector
Carefully disconnect the wiring harness.
④Remove the old sensor
Use an O2 sensor socket or wrench to unscrew.
⑤Clean the sensor port
Remove any rust or debris from the threaded hole.
⑥Apply anti-seize compound (if not pre-applied)
On the threads only, avoid the sensor tip.
⑦Install the new sensor
Thread it in by hand, then tighten with a wrench (do not overtighten).
⑧Reconnect the sensor wiring
Plug the harness back in securely.
⑨Reconnect the battery
Restore power to the system.
⑩Start the engine and check for codes
Tips:We are the source factory, and we will be responsible for any after-sales service. Tel：+86-13806858306
1. When it breaks, there will be a lack of acceleration power.
2. Fuel consumption will increase. If the fault light
comes on,
3. When you take it to a repair shop or a 4S store for repair,
4.They will replace a complete set of the three - way catalytic converter for you.
5. Actually, there's no need to replace the entire assembly.
6. You just need to remove the oxygen sensor.
8. And give it a clean.
Product information last updated on January 8, 2026